![]() I have attached a picture of a model which, in plan, shows a manway (circled in red) that should not be seen because the bottom of the view range is at 8, and the extents of the manway do not exceed 6-6. However, the value for the cut range acts as the bottom of the view range as well because the Bottom and View Depth have no effect on how the Generic Model is displayed. This is not an official translation and may contain errors and inaccurate translations.Īutodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. The platform to the right has only nested families (not sure why I left it there, the platform on the left was sufficient lol). ![]() Give it instance parameters to control the size of this virtual box and it will mask out the finish layers for any view that cuts through the duct at right angles. What if I place the mask into a generic model family If this family has a vertical model line (use invisible lines) the masking region will show up in any plan where the cut plane intersects the model line. So you may resort to Masking Regions in Detail Groups, Copy-Paste Aligned but all of that is suboptimal. Revit Generic Model Invisible In View Software It Is.
0 Comments
Leave a Reply. |